Troy has also ordered the parts necessary to rebuild the fuel sending unit. Once this is done we can get the fuel tank mounted back up under the car. The previous owner had obviously dropped the tank at one point and removed the factory installed anti-squeak insulator pads. His solution was to replace them with good old duct tape and some carpet scraps.
I wanted to go a little higher class, so I bought two actual GM anti-squeak insulator pads I found on eBay. They are self-adhesive and precut to the right width. I will have to trim a little off the length, but I should be able to use the excess for the straps on the bottom of the tank.
Troy and I will be working on KITT tomorrow, so stay tuned for updates. :)
No comments:
Post a Comment